Operating Manual of Inverted Microscope
- 3 -
There are 2 styrofoam boxes within the carton box.
a)
The first box contains 6 objectives (3 pcs plan objectives 10X, 25X & 40X with single
colored ring and 3 pcs plan phase contrast 10X, 25X & 40X with double colored rings and
marked
“
PHP2
”
), 1 trinocular, 2 eyepieces, 1 centering telescope, 3 filters , 1 spare fuse
and1 spare lamp.
b)
The Second box contains 1 body frame, 1 phase contrast condenser, 3 different size stage
brackets holders.
Installation steps
The number in the following installation steps is shown in the installing diagram, such as
“
1
”
is
“
Body
”
in Fig.2
(1) Unpack this unit, take out the body frame 1 and place it on a stable work bench, and remove the
supporting package and the dust cap (bag).
(2) Take out the phase contrast condenser 4. Loosen the screw
①
on the condenser holder 3 and
then install the condenser into the holder, tighten the screw again. As shown in Fig. 3.
(3) Take out the stage bracket 2 (when the stage bracket is used to carry a specimen or observe tissue
in the culture dish), put the desired specification stage bracket flatly in the stage moving device
rack
②
. As shown in Fig. 3.
(4) Remove the dust cap of eyepiece tube, insert the eyepiece 5 into the eyepiece tube, and turn the
eyepieces so that it fits the eyepiece tube well.
(5) There are 6 objectives. Those with single colored ring are plan objectives and with double
colored rings are phase contrast objectives which are also marked
“
PHP2
”
. Install them onto the
nose piece. User can only mount 5 objectives onto the nose piece at any one time. Install them
clockwise in the ascending order of magnification As shown in Fig.4.
(6) Connect the power cord to the power supply socket of the body.
(7) Check if the above installation is secure and safe.
(8) Inspect and gather the accessories and tools enclosed in the package and keep them in a safe
place to avoid misplacement.
Fig.3
①
②
Fig.4