Vista VP960H, Инструкция по установке

Страница: 20 / 49

14
3.4 AUTO SCAN
The Auto scan supports up to 17 programmed positions and the speed at which the dome moves between
these positions. Follow these steps to program Auto Scan:
NUMBER
:01
TITLE :up to 12 characters.
MODE :NORMAL, VECTOR, RANDOM
NORMAL: Move from start point to end point in panning only.
VECTOR:
Move from start point to end point including tilt and zoom simultaneously and
linearly. In some model, the zoom is fixed at wider angle and the zoom magnification
information is not displayed.
RANDOM: Move randomly between the start point and the end point.
SPEED : 1 - 13 steps, the lower number means the slower speed.
SCAN DIR : Set the scan direction, CCW (Counter Clock Wise), CW(Clock Wise)
SWAP : Swap the start point for the end point.
DWELL : Set the dwell time, 01
– 99 seconds
1. Enter the dome menus. Use the Joystick to move to Auto Scan and push the joystick to the right.
2.
Select the ”NUMBER” and set the desired number by pushing the left or right.
3.
Select the “TITLE” and move the joystick to the right.
4. Select the character position required, use up down left right to select the required character, then twist
the joystick to select the character the cursor position moves to the next position automatically. The title
can de completely deleted by selecting ALL DELETE then twist the joystick. Once complete move to
EXIT and move the joystick to the right.
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
MODE : NORMAL
SPEED : 5 STEP
START ANGLE : ----- -----
END ANGLE : ----- -----
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
SAVE AND EXIT(ESC TO CANCEL)
TITLE EDIT MENU
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT (ESC TO EXIT)