COVER SCREWS
FIXTURE COVER
CONVEX LENS
SILICONE O-RING
(UPPER)
FIELD REPLACEABLE
LED ENGINE
FIXTURE HOUSING
FIELD REPLACEABLE
LED DRIVER
SILICONE O-RING
(LOWER)
1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478)
FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.
1162 (08/12)
SILICONE FILLED WIRE NUT,
CONNECT SUPPLY TO
LOAD CONDUCTORS
LOAD CONDUCTORS
LINE: BLACK
NEUTRAL: WHITE
GROUND: GREEN
SILICONE O-RING
(LOWER)
REPLACEABLE
LED ENGINE
SUPPLY CONDUCTORS
LINE, NEUTRAL, GROUND
IMPORTANT NOTE:
DO NOT FILL SEALANT
ABOVE THIS BOSS SURFACE
HOUSING
SEALANT
RE-ENTERABLE
DUCT SEAL
DUCT SEAL
LED ENGINE AND FIXTURE COVER INSTALLATION:
1. To prevent electrical shock, turn main power off at circuit breaker.
2. Remove vinyl label and temporary cover plate (if used).
3. Pull supply conductor wire loop out of housing, cut at center and strip
leads. Place lower silicone O-ring onto fixture housing (see fig. 3).
4. Using the silicone filled wirenuts (provided), connect the load conductors
of the replaceable LED engine to the supply conductors (see fig. 3).
INSTRUCTIONS FOR SEALING WIRING COMPARTMENT:
NOTE:
Failure to properly wire and encapsulate wire compartment will
void product warranty.
5. Use Mastic (provided), to seal the conduit entries from inside wire
compartment to ensure the sealant (see below) does not flow down into
the conduit.
6. Remove Sealant Pouch (provided), from protective cover. Grasp both
sides of the sealant pouch and pull until there is no barrier between both
solutions in the pouch.
7. Mix the sealant by alternately squeezing each end of the sealant pouch,
moving the sealant back and forth until the solutions are completely
mixed together.
8. Cut off the corner of the sealant pouch and immediately pour into the
wiring compartment completely covering the conduit entries - DO NOT
FILL PAST LOWER HOUSING BOSS SURFACE (see fig. 3). Allow sealant to
dry for approximately 20 minutes.
9. Coil LED engine to supply conductor wiring and stuff into housing
cavity.
10. Position LED engine onto lower silicone O-ring and align screw holes.
11. Place upper O-ring onto sealing surface of LED engine.
12. Place convex glass lens onto upper O-ring seal.
13. Place fixture cover onto glass lens and align screw holes.
14. Tighten cover screws evenly until there are no gaps between the
fixture housing, LED engine and cover.
15. Supply power to the luminaire and check for proper operation.
NOTE:
As a recommended practice for installers of all ingrade luminaries,
Vista strongly recommends replacing the gaskets with new ones each
time the fixture is unsealed for maintenance. Relacement gaskets for
future use are provided for your convenience. Additional gaskets for your
maintenance kit may be purchased through your local Vista Professional
Outdoor Lighting distributor.
Figure 3
Figure 4
