10
Care and Cleaning
Cleaning Your Appliance
¨
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
¨
Turn off the appliance first and then unplug the unit from the wall outlet.
¨
Remove all contents.
¨
Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda
solution.
¨
The solution should be about 2 tablespoons of baking soda to a quart of water.
¨
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
¨
The outside of the appliance should be cleaned with mild detergent and warm water.
¨
Dry the interior and exterior with a soft cloth.
¨
Dust or anything else blocking the vent may hinder the cooling efficiency of the appliance.
¨
Vacuum the vent if necessary.
Vacation Time
¨
Short vacations: Leave the appliance operating during vacations of less than three weeks.
¨
Long vacations: If the appliance will not be used for several months, remove all content and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly: blocking it open if necessary.
Moving Your Appliance
¨
Turn off the appliance first and then unplug the unit from the wall outlet.
¨
Remove all the contents.
¨
Securely tape down all loose items inside your appliance.
¨
Tape the doors shut.
Energy Saving Tips
¨
The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
¨
Ensure that door is closed when the appliance is turned on.
Changing the Inner Light
¨
Before removing the inner light, turn off the appliance first and then unplug the unit from the wall outlet. Failure to
do so could result in electrical shock or personal injury.
¨
Remove two screws that hold the control box. While holding the control box, disconnect the LED connector to the
main PCB.
¨
Remove the LED array by removing two screws.
¨
Replace a new LED array and connect it to the main PCB.
¨
Reinstall the control box.
Automatic Defrost
¨
There is no need for manual defrosting of this appliance due to automatic defrosting function.
¨
The ice build-up on the inner back wall during compressor operation will be automatically defrosted once the
compressor cycle is o
ff
.
¨
Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan located above the
compressor, from where it evaporates.
IMPORTANT
:
The replacement of LED light can only be performed by an
authorized technician..
