6
Installation
Free-Standing Installation
This appliance is designed to be installed built-in or free standing.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Ambient temperature below 55
℉
(12.8
℃
) or above 90
℉
(32
℃
) will hinder the performance of this appliance.
This unit is not designed for use in a
garage or any other outside installation.
Avoid locating the appliance in moist areas.
Plug the appliance into dedicated, properly installed, grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized service center.
This unit is not designed to be installed in an
RV or used with an inverter.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for 3–4 hours before
placing wine bottles or beverages in the appliance.
¨
¨
¨
¨
¨
Built-in Installation
The cutout dimension illustrated in figure (A) allows for door
swing and access to the pull-out shelves when installed as a
built-in appliance. If installing between frameless cabinets,
a 1/2 in. wide filler strip or side panel may be needed on hinge
side. The filler strip will act as a spacer between the
appliance case and adjacent cabinet door swing.
The width of the opening must include the filter panels.
¨
NOTE:
The door should protrude at least 1 in. beyond the surrounding
cabinets.
If door reversal is desired, please follow
Changing the
Reversible Door
on page
9
of this manual prior to
installation.
The cutout depth must be 24 in.