6
1. Initial Setup for Installation:
Select the location where the unit to be fixed /
installed. Connect the GSM antenna to the GSM connector provided on the unit. Connect
the GPS antenna to the GPS connector provided on the unit. GSM & GPS marking is
provided near to the connectors for easy identification.
For good GPS coverage, make sure that the GPS antenna has a clear view at the sky
preferably outdoors. Ensure that the top of the antenna is aimed at the open sky.
2. Power Connection:
Connect the unit to DC power source/battery for Power ON.
Ensure that the input voltage to the unit is between 9V DC to 30V DC.
When the units is powered ON, all the three LED's (Red, Yellow and Green) related to
power, GSM and GPS will glow continuously and after some time, the unit will give
“Beep” sound indicating that the unit is ready.
3. LED Indications
LED
Status
Flashing
Red
Yellow
Green
Unit Power ON
Searching for GPS
GPS Not available.
Searching for the GSM
network.
GSM Network not available.
GPS Fix available
GSM Network available.
Note:
The LED will flash at
higher speed when sending
data to remote server.
NOTE:
When the unit is in programming mode, Yellow and Green LED's will not
glow and only Red LED will glow with low intensity.
3
Unit Installation
NOTE:
After completion of the configuration, switch OFF & ON the VTU.
4.9 Edit:
n
Select any configuration details from the history and select “Edit” to edit the details. The
edited details can be stored in to the unit.
4.10 Export:
n
Select the function to Export the configuration history details.
4.11 Find:
n
Select the function to find the configuration details of a particular vehicle from the
history.
4.12 Delete All:
n
Select to delete the configuration history details.
4.13 Close:
n
Select to close the application.
