[4] Viewing Alarm Memory
+ 4
[5] Viewing System Trouble + 5
5
T r o u b l e
Note
Note
Note
Note
Note
If there is no trouble on the system, a long beep sounds after + entry.
Alarm(s)
In Memory
A lit Trouble indicator and beeping from your keypad will alert you if a ‘Trouble’ condition
develops with your security system. Press to silence the beeping and + 5 to view
the cause of the trouble.
The system’s clock needs to be reset. see page 8 for instructions.
Connection to telephone line lost. If house phones aren’t working
contact telephone company. Otherwise, call security company
Bell Fault
Bus Failure
AUX Pwr Failure
Time Clock Loss
Telco Line Loss
Com Failure
Smoke Detector
In Trouble
Trouble Indication Cause
Low battery
Box Tamper
Inspect system control box for damage or open door.
Battery voltage is below acceptable level. Has there been a recent AC power
failure? Wait for recharging or call security company for service.
Call security company for service
Call security company for service
Trouble with Bell/Siren. Inspect and call security company if necessary.
The security system was unable to report to the monitoring company.
Call your security company for service.
Trouble with smoke detector wiring. Call security company for service.
AC Failure
AC power has been lost. UL requires back-up battery of at least 4
hours. Short power outages normally do will not affect your system and
do not require service from your security company.
Zone 01
In Trouble
Trouble with zone wiring. Call security company for service
#
Clear
Blinking Quad Key(s) while the security system is armed or an “Alarm(s) in Memory” display,
indicate that an alarm occured during the most recent arming period. Press + 4 while
the system is disarmed to view the first alarm of the arming period. Press 4 again to view
each additional alarm of the arming period. A long beep tone indicates there were no
additonal alarms. Press to clear the memory or arm and disarm the system. Press
to return to the system’s HOME Mode.
#
Clear
6