10
version 1.0.1
7. Installation
7-1. Lens
Lens is not supplied with the unit. C-Mount or CS-Mount type of lens is useable.
Please select a lens that has a good F-Stop number in order to get the best picture quality. Use
of DC auto iris lens is recommended to achieve the best results for operating this product
effectively.
☞ Caution
Please make sure the surface of the lens is always clear. Clean dirt or water drops with soft cloth
in order to avoid the picture blooming or reflection.
7-2. When using an auto iris lens
(DC-drive)
1. Please take off the sleeve outer cable of the lens by 10mm
2. Please take off the sleeve inner cable of the lens by 2mm.
Pin No.
Lens
DC
No.1 Pin
Damping -
No.1 Pin
D
No.1 Pin
Drive +
No.1 Pin
Drive -
3. Solder the wires on the pin-connector (iris-jack) supplied with the lens according to the
pin configuration as shown in the drawing.
4. Assemble the lens.
5. Connect the Auto Iris jack.
6. Adjust the DIP S/W to DC according to the type of lens.