12
TENSIONING THE RUNNING BELT
For more information and/or how-to videos, visit our Customer Support section on our
website. Contact information is located on the back panel.
Running belt should NOT be moving during tensioning. Over-tightening
the running belt can cause excessive wear on the treadmill as well as its
components. Never over-tighten the belt.
If you can feel a slipping sensation when running on the treadmill, the running belt
must be tightened. In most cases, the belt has stretched from use, causing the belt
to slip. This is a normal and common adjustment. To eliminate this slipping,
turn
the treadmill off
and tension
both the rear roller bolts
using the supplied Allen
wrench, turning them ¼ turn to the right (clockwise) as shown. Turn the treadmill on
and check for slipping. Repeat if necessary, but
never turn
the roller bolts more than
¼ turn at a time. Belt is properly tensioned when the slipping sensation is gone.
TIGHTENS RIGHT SIDE OF ROLLER
TIGHTENS LEFT SIDE OF ROLLER
CAUTION
Содержание T80
