19
Viscount
UNICO
8
-
7
/
/
User Guide
8.5 SAVING DIFFERENT ORCHESTRA VOICES AND PARAMETERS IN THE
COMBINATIONS
General and divisional combinations make possible to save the voice and the settings for each Orchestra
register, so that different voices can be played for each combination (including the Tutti).
For example, recalling a previously programmed combination, the pedal Orchestra voice may be an acoustic
bass, with a 1-octave transposition, while using a second combination the Pedal Orchestra voice may be a
cello, with no transposition, but a bit brighter than the standard setup.
To program combinations with different Orchestra voices, simply select the required voice and/or adjust the
parameters keeping pressed for a few moments the bottom Orchestra register that you desire to edit while
the main video page is displayed:
The first display field (preselected at the access of the video page) shows the selected Orchestra sound. Using
[VALUE +] and [VALUE -] buttons you can select (and play) all the Orchestra sounds.
Others edit parameters are:
o
BRILLIANCE:
voice brilliance.
o
OCTAVE SHIFT:
octave transposer of the notes played with the voice.
o
VOLUME:
voice volume.
o
SUST. PED:
enable of the Sustain switch to act with this voice.
In addition to the standard voices, there also preset voices composed by two voices in Layer or Split mode.
Selecting these voices the video page shows parameters for each voice, indicated as
L
(Left) and
R
(Right) for
the voices in Split mode and
1
and
2
for voices in Layer mode. Split sounds has also the
SPLIT KEY
parameter to set the split point note.
To quit the edit menu press the [EXIT] button.
After Orchestra sounds are programmed it is possible to store them in the desired combination. If you wish
to set a different Orchestra sound in a different combination but associate it to the same register, enter the
edit menu, select the voice, adjust the parameters as required and save all the settings in another combination.
Keep in mind that once a different orchestral sound is selected, it will be associated to that stop also when
future combinations are saved, even if the stop is saved as “off ”. To restore the initial sound (that is, the one
set by the current Organ Style) press and hold for a while the tab / draw stop in off position, or go back in
HR condition by pressing the [C] piston.
NOTES
-
The procedure described above is available only when the main video page is displayed.
-
The changes applied to the Orchestra sounds with this procedure are not applied to Orchestra
voices used by the current Organ Style and their settings. Selecting another style or displaying
the video pages of the VOICE menu, will set the Orchestra registers as prescribed by the Organ
Style and not by the combinations.
-
Crescendo and HRs do not store Orchestra voices and parameters so it is not possible to play
different Orchestra voices for the same register with these memories.
