- 12 -
7.6
Studio / appliance address (unit)
The monolights LOGOS are also available as versions with built-in RFS Interface (
R
adio
F
requency
S
ystem). For remote control respectively flash release via radio, an individual
appliance address and a studio desk top (remote control channel) can be assigned to
each RFS unit by means of the function “unit“ (18).
To carry out the settings, dial the LED “unit“ using the “aux“ key (11). The digital display
(10) shows the letter “U“, followed by an appliance number between 1 and 8. By briefly
pressing the energy control keys “up / down“ (8), the required value can be selected.
When pressing again the “aux“ key (11), the digital display (10) shows the letter “C“,
followed by a studio number between 1 and 8. By briefly pressing the energy control keys
“up / down“ (8), the required value can be selected.
8. Flash tube
The flash tube is coated to ensure an optimal colour temperature. For your security, only
original VISATEC flash tubes must be used. For safety reasons, never operate a unit
without protecting glass in place.
If the monolight LOGOS 800 is used for longer flash sequences, we recommend to
employ the flash tube for LOGOS 1600 / SOLO 1600B - Art. no. 54.301.00.
8.1
Replacing the flash tube
Attention:
Prior to each exchange of the flash tube, the monolight must be fired
down and immediately afterwards disconnected from the mains! Before
exchanging the flash tube, let the monolight discharge and cool down for 10
min.!
The flash tubes are plug-in.
1.) To replace the flash tube, discharge the unit by flashes, disconnect it from power
supply and let it cool off for ten minutes (to discharge the flash capacitors).
2.) Remove the protecting glass.
3.) First pull out the ignition cable and then the flash tube (do not touch the flash tube
with bare hands).
4.) Insert the new flash tube.
5.) Re-insert the ignition cable.
6.) Replace the protecting glass.
7.) Connect the unit to the power supply, now it is ready for use again.
