- 10 -
5.2 Sync
sockets
The synchronous cable, art. no. 54.104.00, may be plugged into the sync sockets (1) or
(2) to release flashes via cable.
The appliance has a synchronous circuit with a low onload voltage to preserve your
camera contact. The synchronous circuit may not be connected in parallel with products
of other manufacturers which operate with high synchronous voltage.
5.3
“
Test
“
key
This “test“ key (5) allows manual release of the monolight LOGOS. The respective LED
lights up, when the flash voltage corresponds exactly to the selected value. During
charging and discharging, the LED goes out and the output display blinks.
6. Ready display visual / audible
6.1
The visual ready display
is the green LED at the “test“ key (5). It lights up only when the
unit is at 100 % charge. After releasing the flash, this LED goes out until the unit is fully
charged again.
6.2
The audible ready signal
"buzzer" sounds when the unit is at 100 % charge. It may be
switched on or off (chapter 7).
6.3
Audible fault signal
When the flash discharge fails, a warning signal of approx. 3 s duration will sound and
the display (10) of the monolight will flash.
7. Setting additional functions
The “aux“ key (11) is used to set the additional functions. With repeated actuation of the
key the following modes can be selected:
•
Setting proportionality level of the modelling light
LED “prop“ blinks (12)
•
Define sequence (serial flashes)
LED “seq“ blinks (13)
•
Charging dimmer switch on / off
LED “dim“ blinks (14)
•
Buzzer switch on / off
LED “buz“ blinks (15)
•
Slow charge switch on / off
LED “slow“ blinks (16)
•
Setting appliance address / studio address
LED “unit“ blinks (18)
•
Return to standard display
no LED blinks
After the setting has been performed, the standard display can be re-activated by
pressing the “aux“ key (11) or automatically after a waiting period of approx. 30 seconds.
