Virutex 4000100, Руководство по эксплуатации

Страница: 12 / 44

12
6. TOOL COMPONENTS
1 Quick change chuck
2 Battery
3 Battery latch
4 LED light
5 Torque regulator
6 Double speed switch
7 On/Off switch
8 Rotational direction selector switch
9 Ventilation slots
10 Screwdriver bits
11 Power unit
12 Charger
7. POWER TOOL ELEMENTS INSTALLATION
AND REGULATION
Before carrying out any procedure, centre the rota-
tional direction selector switch (8) to lock the switch
and prevent the tool's untimely start-up.
Do not over tighten the calibration
elements to avoid damaging the thread.
Assembly/tool replacement (Fig. 1)
With intensive use the drill bit can
become very hot. Use gloves to remove
the bit.
• Open the chuck jaws (1) by turning the front part,
as shown in (Fig. 1).
• Assemble/replace the tool.
• Tighten the chuck (1), as shown in (Fig. 1).
Screwdriver bits/magnetic support (Fig. 2)
Use a magnetic support (not included) for short
screwdriver bits, so they are securely fixed (Fig. 2)
The magnetic support is not necessary if double-ended
bits are used, especially for screwdrivers.
8. HOW TO CHARGE THE BATTERY
The power tool's battery (2) comes partially charged.
The battery (2) must be fully charged before the
first use.
Charging process (Fig. 3)
• Set the rotational direction selector switch (8) to
the centre position.
• Press the battery latch's flange (3) down and remove
the battery (2).
• Connect the power unit (11) to the charger (12).
• Connect the power unit (11) to the power supply.
• Insert the battery (2) into the charger (12) (Fig. 3).
• Once charged, remove it from the charger (12) and
put the battery in the tool.
• Disconnect the power unit (11) from the power supply.
The battery (2) and the charger (12)
get hot during the charging process.
This is completely normal.
9. TURNING THE POWER TOOL ON/OFF
Make sure the rotational direction selector switch
(8) is not in a centred position; this blocks the on/
off switch (7).
Turn on: Press the on/off switch (7).
Turn off: Release the on/off switch (7).
10. DESIGN FEATURES OF THE POWER TOOL
Temperature protection
The temperature protection system allows the power
tool to be automatically deactivated in case of ex-
cessive load or when the battery's (2) temperature
exceeds 70°C. The system protects the power tool
from damage in the event of non-compliance with
the conditions of use.
LED light
By pressing the on/off switch (7), the LED light (4)
turns on automatically and allows you to perform
tasks in low light conditions.
Torque regulator
Turn the regulator (5) to select one of the 18 most
suitable torque setting for the work to be done.
Set the torque regulator (5) to the
"Drill" setting to perform the drilling.
Gradual speed setting
The speed is controlled from 0 to the
maximum speed by pressing the on/off
switch (7). A light pressure produces
low revolutions, which allows the power
tool to start smoothly
Double speed switch
Change the revolutions per minute
(rpm) range only after the motor has
completely stopped.