VirtuFit TR-200I Treadmill
17
EN
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off
automatically to prevent any injuries to the user and to prevent damage to the machine (i.e. motor). When
the treadmill behaves erratically, simply reset the treadmill by turning the power switch off, waiting for 1
minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-checking analyse
(please refer to Self-Checking) to distinguish what type of error problem the machine is encountering.
Before attempting any work on the treadmill, ensure that the power is off and the plug is removed from
the power point. Do not use extension leads as it may lead to power decrease and failure.
ERROR CODE
DESCRIPTION
SOLUTION
E02
Over voltage protection of
motor
1. Make the machine self-checking again
2. Change the controller
E03
Over current protection
1. Clean the dust between running board and belt,
then put some oil
2. If the running belt wear seriously, please change
running belt
E04
The motor open circuit
1. Check the connect wire of motor, if the connect
wire loose, pls connect it again
2. The motor carbon brush wear, replace the carbon
brush or motor
3. Change the controller
E05
EEPROM damage or access
problems
Change the controller
E06
Communication error
Check the connect wire between incline motor and
control board, if it loose or broken, pls change the wire
E07
Incline error when self-
checking
1. Check the connect wire between incline motor and
control board, if it loose or broken, pls change the wire
2. Change the incline motor
E08
Speed error when self-
checking
1. Check the distance from speed sensor to the
magnetic of roller, and ajust it with 3mm
2. Change the speed sensor
E09
Short-Circuit problem
Change the control board
TROUBLE SHOOTING
