VIRTUFIT HTR 3.0i, Руководство пользователя, Страница: 9 / 35

EN
VirtuFit HTR 3.0i Hometrainer
9
• Grab the column lower plastic part (6) and column upper plastic part (12).
• First install rubber cushion 96 into the front support column 12 and connect the signal wires.
• Then align holes of the front support column 12 with the screw holes of the connecting plate, and
use screws 79, the spring pad 46, the flat washer 47 to connect and fix.
• After fixing the front support column 12, install the plastic parts 40, 78 onto the plastic case of the
main frame 1, make rubber cushion stuck between plastic case and front support tube, then lock by
screws 76.
STEP 4
5.Take out 7, 11 and first put the spacer tube 21, the spring pad 46, and
the flat washer 47 on the T-locking latch 11 in order shown in the figure,
then adjust the handle 7 to the appropriate position as shown in the figure,
and finally align the T-locking latch 11 with the screw holes and tighten
them.
6.
​
Take out 16, 17, first align the screw hole of the console rear cover 17
with the holes of the connecting plate, and screw 80 passes through the
flat washer 81 to connect the console rear cover with the connecting
plate, and lock by the self-locking nut 82, then connect the signal wire
through the connecting plate of the console to the corresponding jack of
the console upper case 16 , and finally align the screw hole of the console
upper case 16 with the screw hole of the console rear cover 17, and fasten
ASSEMBLY INSTRUCTIONS