9
VIR
O
TECH
MINI
-
USER
M
ANU
AL
INSTALLING THE PURIFICATION PLATE
Holding the Purification Plate by the ceramic, slowly insert it into the Purification Plate Slot, ensuring that the Purification
Plate is sliding into the grooves on either side.
NOTE
: About halfway in, the Purification Plate Connectors are parted. Continue sliding the Purification Plate into the
Purification Plate Slot until there is approximately one inch of the Purification Plate remaining outside of the Purification
Plate Slot and significant resistance is met. Be careful not to force the Purification Plate further into the Purification Plate Slot
as this could seriously damage your unit.
INSTALLING THE FILTER ASSEMBLY
1. Hold the Filter Assembly with the larger flat side facing the interior of the unit. A sticker reading, “Caution: Reinstall Filter
After Cleaning,” is located on the opposite side of the Filter Assembly. This sticker should be visible when you install the
Filter Assembly.
2. Insert the bottom of the Filter Assembly into the tabs on the rear of the unit and then seat the Filter Assembly on the rear
of the unit.
CAUTION
: If the user fails to insert the Filter Assembly into the tabs appropriately, disassembling the unit in the future
could be extremely difficult.
3. Screw the two brass thumbscrews into their holes at the top corners of the Filter Assembly.
INSTALLING THE REAR COVER
1. Place the tab at the top of the Rear Cover into the hole at the top of the Filter Assembly then lay the Rear Cover flat
against the rear of the unit until the tabs on the sides of the Rear Cover click into place on the unit.
2. Carefully insert the Rear Cover screw into its hole on the Rear Cover (above the Power Cord Port) and tighten.
OPTIONAL PRE-FILTER
