Virax 137550, Инструкция по эксплуатации

Страница: 29 / 192

29
Diagnostics and fault fixes
Important : If you encounter problems not on this list, contact Virax or their representative
for the problem to be dealt with by After-Sales service.
Problem Possible causes Corrective actions
The motor does not operate
when the start button is
pressed.
The power socket is not
connected to the electrical
power source.
Connect the socket to the
electrical power source.
The power source voltage
is too low.
Check the voltage delivered by
the electrical power source. (The
voltage must not be less than
150 V).
The motor brushes are
worn. Replace the brushes by new
ones (see page).
The start button is not
working. Replace the button.(Warning: do
not short circuit the start button.
The motor is burnt out.
Contact Virax or their
representative to change
the motor.
The machine wheel is not
driven by the motor.
The transmission is broken
Contact Virax or their
representative to change
the transmission.
The wheel rotation is slow
or irregular.
The power source voltage
is too low. Check the source voltage.
(It must not be less than V).
The transmission is defective. Contact Virax or their
representative to change
the transmission.
There is forward and
backward play in the wheel.
The bearings are worn.
The pipe is not held
sufficiently by the vice. The jaws are worn. Replace the vice.
The jaws are worn. Replace the jaws.
The dies do not enter
the pipes sufficiently.
The dies are fouled.
Clean the ends of the dies
with a metal brush.
The dies are worn. Replace the die head.
The die numbering has not
been complied with.
Remove the dies and replace
them and ensure the numbering
of the dies is complied with: die
no.1 in socket no. 1, die no.2
in socket no.2, etc.