Maintenance
3
Section 2
Maintenance
2.1 Replacing UV Lamp
Lamp replacement is a quick and simple procedure requiring no special tools. The UV lamp must be replaced after 9000
hours of continuous operation (approximately one year) in order to ensure adequate disinfection.
Procedure:
WA R N I N G
•
Always disconnect power before performing any work on the disinfection system.
•
Always shut-off water flow and release water pressure before servicing.
•
Regularly inspect your disinfection system to ensure that the power indicators are on and no alarms are present.
•
Replace the UV lamp annually (or biennially if seasonal home use) to ensure maximum disinfection.
•
Always drain the chamber when closing a seasonal home or leaving the unit in an area subject to freezing temperatures.
N O T I C E
Do not use water during replacement of UV lamp.
1
•
Shut off the water line to
chamber and release system
pressure before servicing.
•
Close all faucets.
22
0
30
15
45
10 mins
•
Disconnect main power
source and allow the unit to
cool for 10 minutes.
3
1
2
•
Disconnect the lamp
connector and UV lamp from
the retaining nut.
4
•
Rotate the retaining clip
locking tabs to unlock the
lamp connector.
•
Pull the lamp connector along
with the UV lamp from the
retaining nut.
5
•
Disconnect the lamp
connector from the UV lamp.
6
Hg
UV
•
Remove the UV lamp without
twisting and discard the lamp.
Note:
Always hold the UV
lamp at the ceramic ends.
55
Hg
UV
Hg
UV
57
Hg
UV
Hg
UV
•
Insert the new lamp fully into
the sleeve leaving about two
inches of the lamp protruding
from the chamber.
8
•
Connect the lamp connector
to the UV lamp.
