22
©
2002
Directed Electronics, Inc.
4. PPrreessss tthhee ttrraannssm
miitttteerr bbuuttttoonn:: While holding the Valet/Program button, press
the button from the transmitter that you wish to assign to the selected channel.
The unit will chirp indicating successful programming. It is not possible to
teach a transmitter button to the system more than once.
C
Chhaannnneellss ##44--66:: Channels 4 through 6 are used to assign the arm, disarm and panic functions to
separate buttons on the remote control. Teaching a button to Channel 4 erases all information about
that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed.
Similarly, if the remote is set up to use the separate arm, disarm and panic channels and a button
from that remote is entered into channel one, the remote will be erased from memory, and the system
will only recognize the button that was entered into channel one.
C
Chhaannnneell ##99:: If any button from a known transmitter is programmed to Channel 9, all transmitters
will be erased from memory and the system features will revert to the default settings. This is useful
in cases where the one of the customer's transmitters is lost or stolen. This will erase any lost or
stolen transmitters from the system's memory. It can also be used to start from scratch if the trans-
mitter buttons were programmed incorrectly.
5. R
Reelleeaassee.. Once the code is learned, the Valet/Program button can be released.
To exit the learn routine:
One long chirp indicates that Learn Routine has been exited. Learn Routine will be exited if any of
the following occurs:
➤
➤
Ignition is turned off.
➤
➤
Door is closed.
➤
➤
Valet/Program button is pressed too many times.
➤
➤
More than 15 seconds elapse between steps.
Channel Number
Function
Wire Color
1
Arm/Disarm/Panic
2
Silent Mode/Remote Valet/Trunk Release
RED/WHITE
3
Remote Start or other accessories
WHITE/BLUE
4
Arm only
5
Disarm only
6
Panic only
7
Auto-learn Standard Configuration*
8
Auto-learn Single Button Arm/Disarm Configuration*
9
Delete all transmitters
*NOTE: For Auto Learn Configurations, see
Transmitter Configurations
section of this guide.
