Viper 50000605, Инструкция по эксплуатации

Страница: 30 / 33

INSTRUCTION FOR USE ENGLISH
27
WHEEL CHAIN CHECK AND ADJUSTMENT
1. Drive the machine onto level ground.
2. Engage the parking brake.
3. Turn the ignition key to “O”.
4. When the front wheel is loose, adjust the wheel chain adjusting screw (A, Figure 40) on the front of the machine to make sure
the wheel chain is of proper tightness.
5. When the rear wheel is loose, open the cover (C, Figure 41) and the wheel chain cover (A, Figure 41), adjust the wheel chain
adjusting screw (B, Figure 41) to make sure the wheel chain is of proper tightness.
TROUBLESHOOTING
Trouble Possible cause Remedy
The machine does not start when turning
the ignition key to “I”.
The battery connector is disconnected. Connect the battery connector.
The F6 circuit breaker is open. Reset it by pressing relevant switch.
The external charger cable is connected
to the machine. Disconnect the external charger cable
from the machine.
The machine does not move when
pressing the accelerator pedal.
The parking brake is engaged. Disengage the parking brake.
When starting the machine with the
ignition key, the accelerator pedal is
being pressed, or the operator is not yet
on the driver’s seat.
Start the machine with the ignition key,
only after being on the driver’s seat and
without pressing the accelerator pedal.
The seat switch isn’t activated for not
sitting in the right position.
Sit in the right position on the seat.
The F5 fuse is blown. Replace the fuse.
The main broom does not work.
The F7 circuit breaker is open. Reset it by pressing relevant switch.
One-button start button is not pressed. Press one-button start button.
The F5 fuse is blown. Replace the fuse.
The side brooms do not work.
Side broom button or one-button start
button is not pressed. Press side broom button or one-button
start button.
The F8/F9 circuit breaker is open. Reset it by pressing relevant switch.
The F5 fuse is blown. Replace the fuse.
The machine collects little debris/dust.
The vacuum system is turned off. Turn on the vacuum system.
The F11 circuit breaker is open. Reset it by pressing relevant switch.
The dust filter is clogged.
Clean the dust filter with the filter shaker
or remove it for cleaning.
The hopper is full. Empty the hopper.
The blades are not properly adjusted or
are worn.
Adjust/replace the blades.
The brooms are not properly adjusted. Adjust the broom height.
The filter shaker does not work.
The F10 circuit breaker is open. Reset it by pressing relevant switch.
The F5 fuse is blown. Replace the fuse.
The machine exits one-button start mode
and only supports travel mode.
The batteries are discharged.
Charge the batteries. If the trouble
persists, replace the batteries.
The battery run-time is low.
The batteries are dead. Replace the batteries.
The battery capacity is low.
Replace batteries with higher capacity
(see the Technical Data chapter).
For further information, refer to the Service Manual, available at any Nilfisk Service Center.
B
A
C
A
Figure 40
Figure 41