INSTRUCTION FOR USE
ENGLISH
15
Proceed as following:
INSTALLATION:
1.
Insert the Ignition key (53, Figure 3) and turn it to "I". Lift
the deck.
2.
Place brushes (A, Figure 8) or pad-holders (B, Figure8)
under the deck. Use the brush installation stop (D,
Figure8) to help find the proper brush/pad holder position.
3.
Install the brush/pad-holder by pressing the Brush/pad-
holder click on button (F, Figure 8), the brush/pad-holder
will be automatically installed. The rotation direction is
shown (Figure 8). The LED indicator light will flash.
REMOVAL:
1.
Insert the Ignition key (53, Figure 3) and turn it to "I”.
Insure the brush/pad-holder is in the raised (UP) position.
Remove the brush/pad-holder by pressing the brush/pad-
holder release button (E, Figure 8), the brush/pad-holder
will be automatically released. The LED indicator light will
be steady on.
If press brush click-off button and press click-on button, you must turn off ignition key then turn on it, machine can work again
.
ADJUSTING THE BALANCE OF SIDE SPLASHGUARDS
The splashguard height needs to be monitored, and adjusted. While cleaning with
the machine, check the performance of the side splashguards.
A.
If the splashguards are too high, the gap between the splashguard (D) and
the floor, will leave water on the floor during turns.
B.
If the splashguards are too low, the splashguard (D) will deflect too far,
leaving water during turns, and reducing the life of the splashguard.
C.
Proper adjustment is when the splashguards lightly touch the floor from
the front to the rear of the splashguard.
Adjusting procedure as follows:
1.
Insure the deck is in the raised (UP) position.
2.
Loosen the top retention nuts (A), and remove the splashguard
assembly.
3.
Adjust the lower retention nuts (B) up/down.
4.
Re-install the splashguard assembly and check the adjustment.
5.
Repeat 3. & 4. as required until the splashguard adjustment is correct.
6.
Tighten the tope retention nuts (A) to secure the adjustment.
7.
Repeat the procedure on the other side splashguard.
ADJUSTING THE BALANCE OF SQUEEGEE
1.
Install the squeegee and tighten up the nuts (C, Figure 10), then
connect the vacuum hose (B) to the squeegee.
2.
Adjust the squeegee by squeegee adjusting knob (A).
a)
If there is a gap between the ground and middle section of rear
squeegee blade (E), adjust the knob (A) in clockwise direction
(H) until all sections of the rear squeegee blade make good
contact with the ground, and the front blade touches the ground
slightly.
b)
If there is a gap between the ground and both end sections of
the rear blade (D and F), adjust the knob (A) in
counterclockwise direction (G) until all sections of the rear
squeegee blade make good contact with the ground, and the
front blade touches the ground slightly.
If nesseray, adjust the whole squeegee height by adjust the caster wheel (K) height.
Figure 10
Figure 8
Figure 9
