Building Automation Enabled Vantage units have 5 operating modes available to users that may
be enabled and/or adjusted from your building automation control system (see pages 8-10 for
additional information).
• Manual Mode:
User will manually activate the unit to start a disinfection cycle. The unit
will then run its pre-programmed cycle length one time before entering safe mode until
power is cycled on and off again.
• Autonomous Mode:
The unit will automatically activate once the space is unoccupied and
continue disinfection on a regular schedule, adjusting frequency based on level of activity
in the space based on the motion sensor.
• BMS Mode:
The unit will operate disinfection cycles similar to that of manual mode.
However, the unit will have to be activated from within your building automation system
software. For safety, UV light should only be deployed in unoccupied spaces. Please
ensure that you either activate the safety features or have an acceptable alternative
control to prevent occupant exposure to the UV light.
With the building automation capabilities of the Vantage UV Whole Room Unit, users have the ability
to adjust the following:
• Operational Modes & Settings*:
Select operating modes, including type of disinfection
cycle and related selections, such as start time, run time, and motion timeout length, which
indicates how long the unit will wait to attempt re-activation after motion has been detected
• System Monitoring:
Monitor current status of units remotely and troubleshoot operating
• Network Settings:
Configure network settings and/or troubleshoot any networking issues
• Metrics:
Access data on the units, including number of successful cleaning cycles and runtime
over specified period of time or lifetime of unit
BUILDING A
UT
OMA
TION UNIT
S
© Copyright 2021 Violet Defense, LLC All Rights Reserved
VNTG-USRMNL-2021
6
*Modes and configuration options are subject to change. Visit
www.violetdefense.com/resources
for
current user manual or contact the team at Violet Defense with any questions.