The Vantage Wizard can be used to configure units to the preferred programming mode and adjust
related settings. This configuration should be completed before initial operation or as changes need
to be made. To begin, visit
www.violetdefense.com/wizard
to download the Vantage Wizard and
computer configuration instructions. After downloading, run the installer and a shortcut will be placed
on computer’s start menu and desktop.
1.
Configure your computer per instructions.
2. Plug the Vantage unit into your computer using an Ethernet cable.
3.
Open the Vantage Wizard and follow the on-screen instructions to configure the unit, including
operational mode, related settings such as length of motion time-out, runtime for manual or
scheduled mode, and scheduling options, such as start-time for scheduled mode.
4. Once completed, unplug the cable and install the unit. See additional installation instructions on
page 14.
Each standard unit has 3 primary modes available to users. Fixtures must be programmed before
initial use.
• Autonomous Mode:
In this mode, once plugged in, the unit will automatically activate
once the space is unoccupied and continue disinfection on a regular schedule, adjusting
frequency based on level of activity in the space based on the motion sensor. Users may
select the timeout time, which determines how long the unit will wait until resuming
operation after motion is detected.
• Scheduled Mode:
In this mode, the unit will activate at selected time(s) of day during each
24-hour period. Users may schedule up to 8 start times each day to operate for a specified
run time (i.e. 10,15,20,25 or 30 minutes). Users may select the motion timeout, which
determines how long the unit will wait until resuming operation after motion is detected.
The unit may also be configured to activate a disinfection cycle immediately when it is
powered and then continue with the scheduled operational time(s).
• Single Cycle Mode:
In this method, users will manually activate the unit to start a
disinfection cycle. The unit will then run its pre-programmed cycle (i.e. 10,15,20,25 or 30
minutes) one time before entering safe mode until power is cycled on and off again. Users
may select the timeout time, which determines how long the unit will wait until resuming
operation after motion is detected.
ST
AND
ARD UNIT
S
© Copyright 2021 Violet Defense, LLC All Rights Reserved
VNTG-USRMNL-2021
5
