6. NOTE
NOTE
NOTE
NOTE: This side of ladder will be adjusted for
: This side of ladder will be adjusted for
: This side of ladder will be adjusted for
: This side of ladder will be adjusted for OUTSIDE
OUTSIDE
OUTSIDE
OUTSIDE of the pool
of the pool
of the pool
of the pool. The adjustable base supports (C1 &
C2) fit over the support legs (B1 & B2) at the bottom. Snap the adjustable base supports over the bottom
of the support legs and slide them up / down to the outside
outside
outside
outside measurement using the measurement guide
markings (6.1). Don’t forget to add approximately 1 inch for clearance above the pool (from step 3). Align
square bolt holes in base supports with round bolt holes in support legs (6.2). Make certain the measure-
ment settings of the two support legs match, the two that are assembled currently. Secure both adjustable
base supports using four 3/4 carriage bolts with washers & nuts on the inside face (6.3).
6.2
A1
B1
5. Lay the assembled handrails and platform on edge (5.1). Start
with the top support leg positions (5.1). Identify the raised ribs on
the B1 & B2 support legs (5.2). The ribs on the B1 & B2 support legs
fit into a channel in the A1 & A2 handrails (5.3). Fit the B1 & B2 into
the A1 & A2 handrails respectively (A1 + B1 & A2 + B2 - see 5.4 &
5.5). The bolt holes will align when the support legs are fitted into
the handrails properly. Secure both “top” support legs using two 3/4
carriage bolts with washers & nuts on the inside face.
Top
5.1
5.2
5.3
5.4
5.5
Bottom
6.1
6.3
7. With the sub-assembled ladder on edge (7.1), fit a base tread D onto the C1 & C2 adjustable base
supports (7.2). The base tread has a pocket at both ends that fits over the C1 & C2 base supports. The C1
& C2 base supports have a locking tab on the ends; press the base tread onto the base supports until the
button-lock tab snaps through the bottom channels of the base tread (see 7.3). Position the locking tab in
the center of the channel and snap firmly in place (7.4).
7.3
7.4
7.1
7.2
8. Gently, flip sub-
assembled ladder over
onto opposite handrails
so the remaining half
can be completed. The
remaining half will be for
the INSIDE
INSIDE
INSIDE
INSIDE of the pool.
