1. Position A1 & A2 handrail sets together as shown
(1.1). Each handrail has holes to accept the top platform
(1.2). The ends of the platform are designed to fit within
these holes and snap & lock into place (1.3). Fit the
platform, with anti-skid surface and warning labels
facing upward, into the handrails (1.4). Gently tap out-
side of handrails so the button-lock tabs protrude
through and secure platform in place. Make certain tabs
lock securely (1.5). Repeat for both sets of handrails.
A1
A2
1.1
1.2
1.3
1.5
1.4
2. With top platform snapped into handrail sets, secure
A1 & A2 handrails together. Use a 3/4" carriage bolt
with washer & nut at each of the three positions shown
(2.1-2.2). The hardware fits on the inside face of the
handrails. Tighten hardware with an open end wrench
(2.3). Repeat for both handrail sets.
2.1
2.2
2.3
3. Measure both the inside
depth and outside height of the
pool to determine the height
adjustment of the ladder (Detail
3.1). Measure at the point you
plan to position the ladder as
the measurements may vary
Detail 3.1
Detail 3.1
Detail 3.1
Detail 3.1
Measure
Outside
Pool
Measure
Inside
Pool
around the pool. Make certain to choose a location
that has a solid base and is free from high traffic.
Be advised: when the ladder is installed in the pool,
the top platform of the ladder should be just above
the top rail of the pool so the ladder itself, not the
top rail of the pool, supports the weight load on the
ladder (see 3.2). Thus, add approximately 1 inch to
your measurements inside and outside of the pool.
Double check your measurements and record them
for use later in this assembly. Measure accurately
Measure accurately
Measure accurately
Measure accurately.
3.2
4. Understand the height adjustment. Note
that the support legs B1 & B2 have
measurement guides (markings) stamped in
each part (4.1). Use these to set the height
of the ladder both inside & outside the pool.
The adjustable foot supports C1 & C2 fit
over the support legs B1 & B2 respectively
and align at the marking for the appropriate
height required (see 4.2).
4.2
4.1
