BE CAREFUL USING
TOOLS AROUND WATER
READ ALL
INSTRUCTIONS
CAREFULLY
BEFORE
STARTING
ASSEMBLY
HARDWARE LIST
24
-
# 8 x 3/4 inch screws
(all for handrails)
44
-
# 10 x 1 inch screws
12 - for left & right pickets
18 - for spring hinges
6 - for gate latch & striker
8 - for barrier
8
-
# 14 x 1 inch screws
(all for foot extensions)
12
-
3/4 inch bolts
(all for u-shaped connector)
4
-
1 inch bolts
(all for bottom post - top hole)
4
-
1-1/2 inch bolts
(all for bottom post - bottom hole)
4
-
2-1/4 inch bolts
(all for top posts)
32
-
Washers
24 - for u-shaped connector (both sides)
8 - for top posts (both sides)
24
-
Nuts
12 - for u-shaped connector
4 - for top posts
8 - for bottom posts
1
-
Gate latch & striker
3
-
Spring hinges
(one packed special with instruction)
1
-
Barrier cap (on barrier for shipping)
Hardware Measurement Guide
¾
"
""
"
1
"
""
"
2-1/4
"
""
"
1-1/2
"
""
"
Screws (various sizes)
Bolts (various sizes)
Spring Hinges
Gate Striker & Latch
# 1 - POSITION STRINGERS
Set two stringers (Left & Right) on a
flat surface and butt at tops as
shown in Figure 1. Stringers are
marked with a “L” & “R” at the ends
to identify
L
R
Figure 1
# 2 - FIT TOP PLATFORM
Fit top platform into the slots at the top of the stringers; aligning tabs / knobs on the
end of the platform (Figure 2.1) with the holes in the stringers (Figure 2.2). Make
certain the anti-skid surface of the platform is facing upward. Firmly press / tap
platform so button lock tabs of platform protrude through holes in stringers and lock
in place (Figure 2.3). Try not to damage button lock tabs at other end of top platform
Figure 2.2
Figure 2.3
Figure 2.1
#8 #10
#14
