98
Replacing the components of the bottom clamp assembly
(two-stage EFP tripods)
Introduction
1
To dismantle the bottom clamp it is necessary to remove the oval leg.
Consumables
2
The following adhesive will be required:
Loctite 221(Vinten Part No. Z002-026)
White bearing grease (Vinten Part No. Z150-085)
Dismantling - current clamps
3
Remove the clamp knob as follows:
3.1
counter-clockwise to the ‘OFF’ position.
3.2
Using a suitable instrument, such as a flat-bladed screwdriver, carefully remove the knob cap
3.3
Remove the screw
, washer
.
3.4
Remove the grubscrew
4
Remove the oval leg as follows:
4.1
Carefully remove the screw cover
.
4.2
Remove the screw
and T-piece buffer
4.3
Pull the oval leg downwards out of the bottom clamp.
5
Remove the bottom clamp as follows:
5.1
Remove the lower clamp assembly
, the cam moulding
and the
washer
from the bottom clamp moulding
.
NOTE:
The design of the bottom clamp has been modified.
Earlier tripods had two 5 mm grubscrews fitted in the clamp shaft. Later the shaft was
fitted with a locking thread insert and the grubscrews were changed to 1 x M5 x 10 mm.
For Serial Number information, refer to
Содержание Vision Pozi-Loc
Страница 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Страница 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Страница 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...
Страница 107: ...107 Contents Previous Page First Page Next Page Previous View Replacing tripod legs EFP tripods 1 2 3 4 5 2 3 4 ...