29
13.2 If removed, position the PCB in the upper and lower PCB housings (5, 6) and seal the wire exit
holes with Silastic RTV adhesive.
13.3 Push the push-button cap (8) onto the switch in the PCB mounting (4).
13.4 Position the LED in its housing.
13.5 Insert the battery connector into the battery housing (9).
13.6 Position the PCB and wiring in the mechanism housing (2).
13.7 Position wires and secure with hot melt glue.
13.8 Secure the PCB mounting (4) to the mechanism housing (2) with three screws (3).
Pan unit assembly
14
To assemble the pan unit assembly
14.1 If removed, press the bearing (20) into the pan drag housing (8).
14.2 Lightly lubricate the ‘O’ ring (14) with LM grease and install on the shaft in the spherical base
(13).
14.3 Lightly lubricate the thrust bearing (10) with LM grease. With the pan drag housing upside-down,
install a thrust washer (9), the thrust bearing (10) and a second thrust washer (9).
14.4 Lightly lubricate the omniseal (19) with LM grease and install in the seal plate (18), ensuring
omniseal is correctly oriented.
14.5 Lightly lubricate the ‘O’ ring (17) with LM grease and install on the seal plate (18).
14.6 Push the assembled seal plate into position on the pan drag housing (8).
14.7 Install the drag shoe assembly (16) on the pan drag housing (8) and secure lightly with screw
(15), using Loctite 222E.
14.8 Position two drag wedges (11) and the drag actuator block (12) in the drag shoe assembly (16).
14.9 Screw the special thumb screw (
) through the pan drag housing and into the drag
actuator block (12). Tighten the thumb screw until the drag shoe (16) begins to expand, then tighten
screw (15) fully, but do not overtighten. Unscrew the thumb screw slightly.
14.10 Thoroughly clean and degrease the brake drum on the spherical base (13).
14.11 Install the assembled pan drag mechanism in the spherical base and secure with the clamp
washer (22) and the screw (23), using Loctite 222E. Tighten screw (23) down hard, loosen and then
retighten to 0.564 Nm (5 lbf/in.).
14.12 Remove the special thumb screw.
14.13 Lightly lubricate the thrust bearing (7) with LM grease. Install a thrust washer (6), the thrust
bearing (7) and a second thrust washer (6) on the shaft of the pan drag knob (2).
14.14 Lightly lubricate the ‘O’ ring (24) with LM grease and install on the shaft of the pan drag knob (2).