30
14.15 Fill the spring hole in the pan drag housing (8) with LM grease and install the spring (5) and the
ball (4).
14.16 Install the assembled pan drag knob in the pan drag housing (8) and screw into the drag actuator
block (12).
14.17 Using a syringe through the plug holes (21), fill the bowl with 16 cc of Vinten Fluid No. 3.
14.18 Install two plugs (21). Wipe off any excess fluid.
14.19 Install the pan drag indicator (1) on the pan drag knob (2) and secure with grubscrew (3).
15
To install the pan unit assembly
:
15.1 Thoroughly clean and degrease two inner brake pads (21) and the outer brake pad (22). Install
the brake pads in the pan brake calliper (20) and position on the pan drag unit assembly (23). Screw the
brake shaft (27) into the calliper to lightly grip the brake drum.
15.2 Carefully install the pan unit assembly in the mechanism housing (43). Secure with one screw
(39), one screw (42) and one screw (24), in positions noted during disassembly.
Balance mechanism
16
To install the balance mechanism
16.1 If removed, secure buffer (36) to spring end cap (37) using Loctite 495. Ensure components are
concentric.
16.2 If removed, press glacier bearing (32) into spring actuator shaft (33). Assemble spring actuator
shaft in adjustment slide (30) and secure with dowel pin (31), using tool
centralize pin.
16.3 Lubricate balance mechanism components as follows:
16.3.1
Thrust bearing (16) and spring actuator shaft (33) - Castrol LM grease.
16.3.2
Thread of balance knob (19) - Easyrun 50 grease.
16.4 Degrease the threaded bore of actuator shaft (33) and thread of screw (38).
16.5 Install spiral ring (18) on balance knob (19) and screw into adjustment slide (30).
16.6 Position spring (35), assembled buffer/spring end cap (36/37) on spring actuator (34).
16.7 Position assembled spring actuator in the mechanism housing (43).
16.8 Install a thrust washer (16), the thrust bearing (17) and a second thrust washer (16) in the
mechanism housing (43).
16.9 Slide assembled balance knob/adjustment slide/actuator shaft into the mechanism housing/
spring actuator, ensuring slot in adjustment slide is to the left.
16.10 Install the adjustment slide pin (29) in the mechanism housing (43), ensuring pin engages in slot
in adjustment slide. Secure pin with Silcoset.