30
11.15 Install assembly in centralizing fixture (
).
11.16 Using the fixture, expand the drag shoe assembly.
11.17 Remove screws (35) one at a time and re-install using Loctite 221 on threads and Loctite 601
under heads. Torque-tighten screws to 7.34Nm (65lbf in.).
11.18 Remove from fixture.
11.19 Install ‘O’ ring (31) in tilt drag cover/brake disc assembly (30).
11.20 Degrease and prime six screws (1) with Loctite N primer and allow to dry.
11.21 Install completed outrigger assembly on tilt drag housing (2). Align fixing holes and secure with
six screws (1) and Loctite 222E.
11.22 Install pan brake pivot (13) in pan brake shoe assembly (12) and install in tilt mechanism.
11.23 The remaining tilt mechanism components are installed after assembly of the balance
mechanism.
Balance mechanism
12
Assemble/install the balance mechanism as follows (
12.1 If the bearing (11) has been removed from the mechanism housing cover (22) a replacement
may be installed without heating the cover. It is essential that a suitable press, fitted with a mandrel
adaptor and support ring to match the bearing, is used. Proceed as follows:
12.1.1
Remove all traces of adhesive from bearing and seating in mechanism housing cover.
Degrease bearing seating and outer race of bearing.
12.1.2
Apply Loctite 641 to outer race of bearing and press into mechanism housing cover,
ensuring bearing is correctly seated.
12.2 Assemble the pan mechanism (
)
12.3 Assemble the tilt mechanism (
12.4 Using Loctite 495, adhere buffer (33) to end washer (34).
12.5 Lightly lubricate components as follows:
12.5.1
All moving contact surfaces of the balance mechanism with grease GP50.
12.5.2
All bearings and shims with white bearing grease.
12.6 Install bearing shim (9) on RH side plate (7) and install in mechanism housing (17). Secure with
circlip (12).
NOTE:
The design of the tilt drag cover/brake disc assembly changed from Serial No. 1288.
Ensure correct housing and ‘O’ ring are replaced.
