Vintec V 150 SG2E, Инструкция по эксплуатации

Страница: 11 / 12

11
GB
Automatic defrosting Automatic defrosting
The wine cooler is defrosted automatically.
Defrost water runs through a pipe and is
collected in a tray above the compressor
where the heat generated by the compres-
sor causes it to evaporate. The defrost
water tray should be cleaned at intervals.
Cleaning
Switch off the appliance by pressing the
on/off button before cleaning it inside. The
cabinet is best cleaned using warm water
(max. 65°C) with a little mild detergent.
Never use cleaning agents that scour. Use
a soft cloth. Rinse with clean water and dry
thoroughly. The defrost water channel, in
which condensation from the evaporator
runs, is located at the bottom of the rear
inside wall of the cabinet and must be kept
clean. Add a few drops of disinfectant, e.g.
Rodalon, to the defrost water drain a couple
of times a year, and clean the drain using
a pipe cleaner or similar. Never use sharp
or pointed implements. The sealing strip
around the door must be cleaned regu-
larly to prevent discolouration and prolong
service life. Use clean water. After cleaning
the sealing strip, check that it continues to
provide a tight seal. Dust collecting on the
condenser on the rear of the cabinet, the
compressor and in the compressor com-
partment is best removed using a vacuum
cleaner.
Defrosting, cleaning and maintenance
Replacing the light tube
Disconnect the power by pressing the on/off
button. Remove the lamp cover using a
small fl at-headed screwdriver. Replace the
PLC tube (11 W).
Refi t the lamp cover, reconnect the power
supply and start the appliance by pressing
the on/off switch.