Vintage Air 754562, Руководство пользователя

Страница: 16 / 30

16
www.vintageair.com
905458 REV E 07/10/18, PG 16 OF 29
Evaporator Installation (Final)
1.
2.
With the louver bezel mounted and the dash bracket secured to the evaporator, drill a 7/32” hole aligned with
the center of the slot on the dash bracket. Drill through the OEM dash brace, the bottom of the dash and the
top of the louver bezel. Attach the dash bracket to the dash through all drilled holes using a 10-32 x 1” pan
head screw, (2) 3/16” flat washers, and a 10-32 nut with star washer (See Photo 1 and Figure 1, below).
NOTE: Install this screw upward from the louver bezel.
Check that the evaporator unit is level at the passenger side of the drain pan (See Photo 2, below). If the unit
is not level, check to ensure installation steps were properly performed.
Photo 2
Photo 1
Drill 7/32”
Hole
Check that Evaporator Unit is Level
at Passenger Side of Drain Pan
10-32 x 1” Screw, (2) 3/16”
Flat Washers, and 10-32 Nut
with Star Washer
3/16” Flat Washer
3/16” Flat Washer
10-32 x 1” Pan Head Screw
10-32 Nut with
Star Washer
Louver Bezel
Dash Bracket
Dash Brace
Figure 1