Vintage Air 564191, Инструкция по эксплуатации

Страница: 6 / 34

6
www.vintageair.com
905644 REV A 01/10/19, PG 6 OF 33
Condenser Assembly and Installation
1.
2. Refer to separate instructions included with the condenser kit to install the condenser.
Binary switch installation (Refer to condenser instructions).
Compressor and Brackets
1. Refer to separate instructions included with the bracket kit to install the compressor bracket.
Engine Compartment Disassembly
1.
2.
3.
4.
5.
6. Disconnect the battery.
Remove the battery and battery tray (retain) (See Figure 1, below).
Drain the radiator.
Remove the hood latch and hood latch support assembly (retain) (See Figure 1, below).
Remove the OEM heater hoses (discard) (See Figure 1, below).
Remove the OEM blower motor assembly (See Figure 1, below).
NOTE: To remove the blower assembly
(under hood) and the air distribution system (under dash), the factory manual recommends the
following: Remove the right lower rocker molding. Remove the fender attaching bolts. Remove
the skirt-to-fender and skirt-to-reinforcement screws. Pull out on the lower portion of the fender,
moving the skirt away from the fender flange and firewall. Block the skirt with a 2” x 4” block of
wood. To avoid damage to the paint and sheet metal, and for ease of removal and replacement
of components, Vintage Air recommends that the right fender be removed, and the inner panel
lowered. Removing the right front tire will provide easier access to the inner fender bolts.
NOTE: Before starting the installation, check the function of the vehicle (horn, lights, etc.) for proper
operation, and study the instructions, illustrations, & diagrams.
Perform the Following:
Figure 1
Outer
Fender
Battery &
Battery Tray
Heater
Hoses
Inner
Fender
Heater Hose
Clamp
OEM
Blower Motor
Assembly
Hood Latch
and Support
Assembly
Radiator