Vintage Air 561191, Инструкция по эксплуатации

Страница: 10 / 34

10
www.vintageair.com
905647 REV B 07/17/19, PG 10 OF 33
Figure 1
Hose Adapter Installation
1.
2.
Install (4) S-clips onto the driver side hose adapter and (2) S-clips onto the passenger side hose adapter as
shown in Figure 1, below.
Install the driver & passenger side hose adapters onto the OEM louvers (See Figure 1, below).
Passenger Side
Driver Side
Early-Model Kick Panel Modification
1.
2.
3.
4.
Remove the OEM kick panel grille retaining screw and grille (discard) (See Photo 1, below).
Disconnect and remove the fresh air door cable from the OEM lever housing (discard) (See Photo 2, below).
Remove the fresh air door assembly from the OEM kick panel by lifting up on the door toward the spring and
sliding it out of the hinge housing (See Photo 3, below).
Trim the fresh air door housing flush with the back of the OEM kick panel, and discard the excess material
(See Photo 4, below).
Photo 1 Photo 2
Photo 3
OEM
Driver Side Louver
Hose Adapter
49880-VCI
OEM
Passenger Side Louver
Hose Adapter
49881-VCI
(2) S-Clips
Photo 4
Remove Retaining
Screw and Grille
Disconnect Fresh Air
Door Cable and Remove
Remove Fresh Air
Door Assembly
Trim Fresh Air Door Housing Flush
With Back of OEM Kick Panel
NOTE: If the vehicle is equipped with a late-model kick panel, proceed to Page 11.
(4) S-Clips