7
904184 REV A 6/17/11, INST 73-80 CHEV P-UP w/ AC EVAP KIT PG 7 OF 27
GLOVE BOX DOOR AND GLOVE BOX ASSEMBLY (RETAIN) (SEE FIGURE 2 BELOW)
UNDER DASH STEERING COLUMN COVER (RETAIN) (SEE FIGURE 2)
INSTRUMENT PANEL BEZEL (RETAIN)
DASH PAD (RETAIN) (SEE FIGURE 2)
DISCONNECT ALL WIRES AND CABLES FROM CONTROL PANEL.
REMOVE CONTROL PANEL (DISCARD) REFER TO CONTROL PANEL CONVERSION KIT INSTRUCTIONS.
ASH TRAY (RETAIN)
ALL HOSE AND DUCTING FROM OEM LOUVERS (SEE FIGURE 2a BELOW.)
AC/ HEATER ASSEMBLY (DISCARD) (SEE FIGURE 2a)
DEFROST DUCT ASSEMBLY (DISCARD) (SEE FIGURE 2a BELOW)
PASSENGER SIDE KICK PANEL ASSEMBLY. (RETAIN KICK PANEL COVER &
KICK PANEL CAP, BUT DISCARD DOOR & ACTUATOR) SEE FIGURE 2b.
APPLY 1/4” BEAD OF SILICONE ON BACK SIDE OF KICK PANEL BLOCK OFF PLATE.
INSTALL KICK PANEL BLOCK OFF PLATE USING (2) #8 x 1/2” PH PAN HEAD
SCREWS (SEE FIGURE 2c).
NOTE:
FOR EASE OF INSTALLING EVAPORATOR UNDER DASH, IT MAYBE
HELPFULL TO REMOVE THE (2) OEM BOLTS UNDER THE DASH ON THE
PASSENGER SIDE DOOR PILLAR AND PULL BACK DASH.
NOTE:
SOME MODELS MAYBE EQUIPPED WITH DASH BRACE. (REMOVE AND
RETAIN). (SEE FIGURE 2a)
PASSENGER COMPARTMENT
REMOVE THE FOLLOWING:
FRESH AIR
DOOR ASM
KICK PANEL
COVER
KICK PANEL
COVER
(2) #8 x 1/2”
PH PAN HEAD
SCREWS
KICK PANEL
BLOCK OFF
PLATE
62438-LCE
SILICONE
BACK SIDE
KICK
PANEL
CAP
FIGURE 2
FIGURE 2a
FIGURE 2b
FIGURE 2c
CONTROL
PANEL
INTSTRUMENT
PANEL
BEZEL
DEFROST DUCT
ASSEMBLY
AC/ HEATER
ASSEMBLY
(2) OEM
BOLTS
DASH
BRACE
ALL HOSE
AND RELATED
DUCTING
FROM LOUVERS
UNDER DASH
COVER
GLOVE BOX
DOOR &
GLOVE BOX
DASH
PAD
ASH
TRAY
