8
www.vintageair.com
901345 REV A 05/12/17, PG 8 OF 12
Hardline & Binary Switch Installation
1.
2.
Lubricate (2) #6 O-rings as shown in Figure 1, Page 7. Install the #6 drier/condenser hardline as shown in
Photos 8 and 9, below. Tighten fittings as shown in Figure 1, Page 7.
NOTE: Orient the #6 drier/condenser
hardline as shown in Photo 9, below. Reversing the hardline orientation will push the drier into the
wrong position. Tighten the 1/4-20 nut with star washer securing the drier to the drier bracket at
this time.
Install binary switch onto the drier as shown in Photo 9, below.
NOTE: The binary switch and the drier
each come with an O-ring. Only one of the (2) O-rings will be used.
Nylon Spacer Installation
1.
Install (4) 5/16” nylon spacers on the passenger and driver side condenser bracket weld studs as shown in
Photos 10 and 11, below.
#6 Drier/Condenser
Hardline
100998
#6 Condenser
Fitting
Passenger Side
Condenser Bracket
Assembly
643113
Drier
Drier
(2) Weld Studs
(2) Weld Studs
Binary Switch
(2) 5/16”
Nylon Spacers
(2) 5/16”
Nylon Spacers
Driver Side
Condenser Bracket
Assembly
643111
Passenger Side
Condenser Bracket
Assembly
643113
Photo 8
Photo 9
Engine Side
View
Engine Side
View
Photo 10
Photo 11
