Vinotemp WINE-MATE WM1500 HTD, Инструкция по использованию и уходу

Страница: 13 / 23

- 12 -
2.1 LED Functions
LED MODE FUNCTION
ON Compressor enabled
Flashing Anti-short cycle enabled
ON Defrost cycle enabled
ON Fan enabled
Flashing Fan delay after defrost enabled
ON Alarm occurring
ON Temperature measuring unit
Flashing Programming mode
3) Alarm Signals
3.1 Code Description
MESSAGE CAUSE FUNCTION
P1
Temperature probe faulty Compressor switching to Con and CoF
HA
High temperature alarm Outputs unchanged
LA
Low temperature alarm Outputs unchanged
CA
External alarm All outputs off
3.2 Alarm Recovery
Probe alarms P1”, start a few seconds after the fault in the related probe; they
automatically stop a few seconds after the probe restarts normal operation.
Check connections before replacing the probe. Temperature alarms “HA”, “LA”
automatically stops as soon as the temperature returns to normal value. Alarm
“CA” (with i1F=PAL) recovers only by switching off and on the instrument.
4) Temperature Set-Point
4.1 How to see the set-point
1. Press and immediately release the
SET key, the display will show the set-point
value.
2. Press again and immediately release the
SET key or wait for 5 seconds to
display the probe value again.
4.2 How to change the set-point
1. Press the
SET key for more than 3 seconds until the “°C” or “°F” LED starts
blinking and the set-point will be displayed.
2. To change the set value, press the up/down keys
/ within 10 sec.
3. To store the new set-point value, press the SET key again or wait 10 sec.
5) Parameter Programming