Vinotemp WINE-MATE WM-2500SSVWC, Руководство по установке операции "Забота"

Страница: 9 / 29

-8-
5. Manual Defrost
Press and hold the defrost key until defrost starts. The defrost indicator will be
on.
6. Parameter Programming
1) Press and hold the SET + keys until the
“ °C” or “°F”
LED starts flashing,
then release the keys.
2) Press and hold again the
SET + keys until the Pr2 label is displayed, then
release the keys. The first parameter Hy will be displayed.
3) Press up/down keys / to scroll to the required parameter within 10 sec.
4) Press the
“
SET
” key to display its value.
5) Use up/down keys to change its value within 10 sec.
6) Press
“
SET
” to store the new value and the display will flash 3 times.
7) To exit : Press SET + or wait 15sec without pressing a key.
PARAMETER DESCRIPTION DEFAULT VALUE
Set set-point (°) 55
Hy temperature regulation differential
(°)
4
AC anti-short cycle delay (min) 10 (hidden)
Con compress on with probe faulty (min) 15
CoF compress off with probe faulty (min) 30
CF temperature unit (°F/ °C) F: Fahrenheit
rES display resolution in: integer
dLy temperature display delay (min) 1
ot probe calibration (°) 0
LS minimum set-point (°) 50
US maximum set-point (°) 65
idF defrost interval time (hour) 12
MdF defrost endurance time (min) 30
ALC temperature alarm type rE: relative to set-point
ALU high temperature alarm (°) 10
ALL low temperature alarm (°) 10
AFH alarm recovery differential (°) 5
ALd temperature alarm delay (min) 60
dAO temperature alarm delay on startup
(hr)
23
SAA heater set-point (°) 40
SHy heater regulation differential (°) 4
FSU fan action Std
FnC fan operating mode C-n: on with compressor & off during
defrost
Fon fan on with compressor off (min) 0
FoF fan off with compressor off (min) 15
NOTE Depending on the controller, not all parameters are available.