Vinotemp WINE-MATE WM-2500SSVWC, Руководство по установке операции "Забота"

Страница: 8 / 29

-7-
4) Alarm Signals
The alarm codes are described as follows.
MESSAGE CAUSE FUNCTION
P1 Temperature probe
faulty
Compressor switching to Con and
CoF
HA High temperature
alarm
Probe temperature ALU higher than
the
setting temperature; Outputs
unchanged
LA Low temperature
alarm
Probe temperature ALL lower than
the setting temperature; Outputs
unchanged
CA External alarm All outputs off
Probe alarms P1”, start a few seconds after the fault in the related probe; they
automatically stop a few seconds after the probe restarts normal operation. Check
connections before
replacing the probe. Temperature alarms “HA”, “LA”
automatically stops as soon as the temperature returns to normal value. Alarm
“CA” (with i1F=PAL) recovers only by switching off and on the instrument.
2. Temperature Setting
•
Set the temperature at 55
°
F for the optimum aging of wine
•
On initial start-up, the time required to reach the desired temperature will
vary, depending on the quantity of bottles, temperature setting and surrounding
temperature.
•
Allow 24 hours to stabilize the temperature for each new temperature setting
operation
3. How to see temperature set-point
1) Press and immediately release the SET key, the display will show the set-point
value.
2) Press again and immediately release the
SET key to display the probe value.
4. How to change the set-point
1) Press and hold the SET key until the
“°C” or “°F” LED starts flashing and the
set-point is displayed.
2) Press the up/down keys
/ to change the set-point value within 10 sec.
3) Press the SET key again to store the new set-point value.
NOTE The unit turns on at set-point Set plus regulation differential Hy after
anti-short cycle AC has elapsed; the unit turns off at set-point Set .