Vinotemp WINE-MATE WM-1500LOWP, Инструкция по установке, использованию и уходу

Страница: 16 / 24

- 15 -
7. How to calibrate the air probe
If the actual cellar temperature differs from the setting temperature, set parameter ot =
actual cellar temperature minus set-point.
8. How to adjust defrost cycle
I n case there is excessive frost, the parameters FnC = C-y , idF = 4 and MdF = 20 can be
used to avoid frost.
9. How to adjust the humidity
The parameter Fon is used to adjust the humidity in the wine cellar. Higher Fon results
in higher relative humidity. Use a separate hygrometer to monitor the humidity.
10. How to set alarm call
1) S peech notice will be sent to your phones when the cellar temperature is ALU higher
or ALL lower than the set-point Set .
2) In order to test the call function, set parameters Ald = 0 and dAO = 0. After testing,
set Ald = 60 and dAO = 23.
11. How to set low cellar temperature heater
The heater turns on at SAA minus Shy; the heater turns off at SAA .
NOTES:
•
Use a forced air heater to warm up the wine cellar.
•
If there is a thermostat on the heater, bypass it or set the thermostat at the highest
level.
•
If the heater runs more than 10 A current, use a 120VAC coil contactor