Vinotemp WINE-MATE WM-1500LOWP, Инструкция по установке, использованию и уходу

Страница: 7 / 24

- 6 -
2. Cooling Unit Installation
•
The cooling unit produces cooling supplied into the cabinet, meanwhile it also
generates heat that must be exhausted outside the cabinet. So the cold-air supply
and warm-air return must be separated from the hot-air exhaust and ambient-air
intake. Foam tape gasket may be used to seal them. The cooling unit must intake
adequate fresh ambient-air to work properly. The ambient-air intake and hot-air
exhaust must not be short-circulated.
1) Making Cutout
•
Make a rectangular through hole at the rear wall of the cabinet with 1/4” less than
the width and height of the cooling unit. Make 1/2” tabs to place the gaskets as
shown in Fig. 2.1.
•
If it is a top exhaust installation, make another rectangular hole at the top of the
cabinet with the length and width of the top exhaust as shown in Fig. 2.2.
•
Install 2 pieces of 1/4” ID wood thread inserts on the ceiling as shown in Fig. 2.3.
•
Install the rear gaskets (1/2” foam tape) as shown in Fig. 2.4.
•
If it is a top exhaust installation, install the top gaskets on the cooling unit as shown
in Fig. 2.5.
2) Installing Cooling Unit
•
Push the cooling unit towards the mounting tabs until it stops and press the gaskets
as shown in Fig. 2.6.
• Use two mounting brackets and two 1/4” screws with 7/16” wrench to secure the
cooling unit as shown in Fig. 2.6.
3) Low Profile Front Grille
•
Install an exhaust cover to redirect the hot air to the front as shown in Fig. 2.9.
•
Install the low profile front grilles as shown in Fig. 2.9.
Fig. 2.1 Rear Exhaust Cutout