Vingtor Stentofon 1021001100, Инструкция по установке и эксплуатации

Страница: 23 / 32

23
VSS-V2 Technical Manual
A100K11209 v.1.4
Default level is 5 LEDs lit. At this level the output in the internal speaker
will be the same as the sound levels at the outdoor listening post, which
is the sound levels at the microphones. It is marked with the symbol as
shown on the left.
8.1.5 Squelch
The panel has a squelch button (Squelch). By pressing the squelch
button, the level of UTP (Upper Threshold Point) in DSP is adjusted. It
is not possible to listen to noise that is lower than this level. The level
is the same for all panels - hence, adjusting the level on one panel
changes them all. Adjusting the level with the squelch button will be
indicated by direction LEDs.
Adjustment of squelch is carried out according to the specifics of the
noise. If the noise is white, e.g. common wind noise, then the UTP point
will adjust itself so as not to cause false alarms.
If the noise is periodic, e.g. mechanical vibrations, wind howling or
sea gulls, then the algorithm could trigger a false detection, as it is not
possible to differentiate these sounds from the horn sound, which is also
periodic. Short burst periodic sounds will be filtered by the algorithm, but
persistent periodic sounds can be problematic. The squelch button can
raise the UTP point above these noise sources to avoid false detections.
8.1.6 Override function (audio)
The override button (Override) is used to send audio from the
microphone unit directly to the speaker. The speaker will output no
matter if there is horn detection or not and be in listen mode. Override is
individual for each panel. The override button is latching and press/listen
mode is indicated by the system LED 1s toggle. Override will time out
after 15s.
8.1.7 Power
The power button is for powering the panel on or off. Indication for
power ON is via the green LED.
8.2 Web Interface
8.2.1 Open site
● Microphone status and LED direction.