VINCENT SV-700, Инструкция по эксплуатации

Страница: 42 / 72

42
Vincent
OPERATING THE APPLIANCE
Operation Button(s) Description
Switch on and off POWER (6)
The amplifier is switched on and off using this button at the front panel,
there is no standby option. When switched off the device is internally sepa-
rated from the AC power. When switched on, one of the LED’s near the
input selector (1) is lit. As a precaution, before switching on, the volume set-
ting (2)(20) should be reduced. The switching operation is signalled via the
cables connected in the terminal “POWER CONTROL” (13).
Select an input
INPUT (1)
Input
selector
buttons
(18)
On the front panel: if the “INPUT” dial is turned clockwise or in the opposi-
te direction, each of the input channels will be selected in turn and this swit-
ches the playback between the devices connected to the corresponding
input sockets (11). The relevant LED lit over the “INPUT” selection dial
shows which source is currently selected.
Using the remote control: A short touch on the button for the desired input
channel (e.g. “S1” changes to the playback of the audio source connected
there.
The illuminated LED near the input selector (1) indicates which audio source
is currently selected for playback. Before switching over the input channel,
the volume (2)(20) should be turned down as a precaution!
Change the volume
VOLUME (2)
VOLUME
p
/
q
(20)
On the front panel: Turn the knob “VOLUME” clockwise to turn up the volu-
me and counter-clockwise to turn it down.
Using the remote control: Hold down the button “VOLUME
p
” to turn the
volume up. Use “VOLUME
q
” to turn it down.
The volume setting affects the signals for the loudspeakers and additional
main amplifier channels (9) but never influences the signal at the output
“REC OUT” (10). If a pair of headphones is plugged into the front of the
device, the volume control no longer affects the loudspeakers but instead
affects these headphones.
Select amplifier mode
CLASS A /
CLASS AB (3)
This button toggles between Class A and Class AB modes. In this way you
can switch from the better sounding Class A mode to the energy-saving
Class AB mode with less waste heat, for instance for sound reproduction for
a party, where absolute high fidelity is not necessary. It is allowed to use
this switch even while music is being played back.
Individually activate or
deactivate speaker out-
puts A and B
SPEAKER A
SPEAKER B
(7)
To play back music at least one loudspeaker must be attached to the ampli-
fier (a practical choice would be connectors “A”). The output you use must
be activated using the corresponding button “SPEAKER” (LED illuminated).
Only if a second speaker is used, it is necessary to activate the second
speaker output “B”.