Vincent
23
1. POWER LED
This LED is lit as long as the
PHO-111 is connected to its
power supply that is connected
to the mains and ready for use.
2. GND: Ground clamp for
the record player
In addition to the stereo signal
connection cable most record
players are equipped with a
grounding cable that can be
recognized by the cable lug at
the end of the cable. This lug
has to be fitted to the clamp
“GND”.
3. IN: signal input from
the record player
The audio output (or as well an
attached audio cable) of the
record player must be connec-
ted to these input sockets.
4. MC/MM I/MM II:
pickup type switch
At this switch the type of record
player pickup system has to be
selected to adapt the phono
preamplifier PHO-111 to that
system. See section “Setting
the type and electrical capaci-
ty of the pickup system”.
5. OUT: signal output
to the amplifier
A pair of RCA input sockets of
your system’s audio amplifier
must be connected with these
output sockets.
6. 12-16V AC: power supply
input of the PHO-111
Plug in the power connector at
the end of the cable (8) of the
supplied AC adaptor (7).
Connect the AC adaptor to the
mains voltage. Always connect
the AC adaptor to the mains
before you switch on the ampli-
fier/preamplifier!
Power Supply
7. AC ADAPTOR: power supply
with power plug
This power supply adaptor is
supplied with the PHO-111 and
converts the mains voltage to a
more suitable supply voltage.
After you made the connection
to the PHO-111, plug it into a
mains socket as the last step of
the Installation.
8. Power Supply Cable
Make a connection to the PHO-
111 back plate power socket
(6).
