Vimar ELVOX RS14, Инструкция по установке и эксплуатации

Страница: 22 / 88

20
3.5 Function test
3.5.1 Learning run for determining the driving power
Check:
After express programming and after making changes to the programming menu, the following learning runs andchecks must be carried out.
The operator system determines the maximum required driving power during the first two runs after setting the end positions of the door.
• Operate the operator system (with the door coupled) to drive the door once from the CLOSED position to the OPEN position and back to the CLOSED
position without interruption.
During this learning run, the operator system determines the maximum push and pull forces and the reserve power required to move the door.
Test:
After pressing the (+) button:
The door must open and travel
to the saved OPEN end position.
After pressing the (–) button:
The door must close and travel
to the saved CLOSED end po-
sition.
After pressing the hand transmit-
ter button:
The operator system must move
the door in either the OPEN or
CLOSE direction.
After pressing the hand transmit-
ter button while the operator sy-
stem is running:
The operator system must stop.
When the button is pressed
again, the operator system
moves in the opposite direction.
3.5.2 Checking the automatic cut-out
Caution!
The automatic cut-out must be correctly programmed for the CLOSE and OPEN directions to prevent damage to persons or property.
Automatic cut-out, OPENING
For drive systems where the door has openings in the door wing (diameter of opening > 50 mm):
• Apply a load of 20 kg to the middle of the lower edge of the door whilst the door is running.
The door must stop immediately.
Automatic cut-out, CLOSING
• Place a 50 mm high obstacle on the ground.
• Drive the door towards the obstacle.
The drive system must stop and reverse when it comes into contact with the obstacle.
Advice:
The parameter settings are still saved if the power supply is disconnected.Only a reset causes the driving power settings for the OPEN and CLOSE
directions to revert to the factory settings.
EN