Vimar Eikon 20440, Инструкция по эксплуатации

Страница: 24 / 76

20 - ENGLISH
6. USING THE THERMOSTAT.
6.1 Operation.
Make the electrical connections and install the appliance .
Select the required function by pressing its associated key; the
parameters will be displayed in blinking mode and they can be
modified with the “–” “+” keys .
Access to the functions to modify the parameters is timed; the
settings are automatically saved at the end of this time or upon
exiting the menu.
If the relay is activated, the symbol is displayed when on heating
and the symbol when on air conditioning .
6.2 Configuration.
• KEY
+ KEY
CNF configuration menu selection .
In the CnF configuration menu (accessed after ~ 5 seconds) it is
possible to make the following settings:
• HEATING/AIR-CONDITIONING.
Used to select the required function .
From the CnF press the key and, using the “
–
” “
+
” keys,
select the required function .
• TEMPERATURE DIFFERENTIAL.
Used to set the value of the temperature differential . The tem-
perature differential is the difference between the set tempera-
ture and the actual temperature of switching the system on or off .
Adjusting the temperature differential to the type of system avoids
continual switching on and off; high-inertia systems (for example
systems with cast-iron radiators) need a low temperature differ-
ential, while low-inertia systems (for example fan heaters) need a
high one .
Example.
By setting the room temperature to 20 °C and the temperature
differential to 0 .3 °C, the system will switch on when the room
temperature falls to 19 .7 °C and it will switch off when it reaches
20 .3 °C .
From the CnF menu, press the key until the temperature
differential is displayed ( d0.2 °C blinking); then, using the “
–
” “
+
”
keys, set the required value .