Villager VST 2820, Оригинальная инструкция по эксплуатации

Страница: 28 / 147

13
Villager VST 2820 (GB)
SNOW CLEARING
1. First check that there are no stones, rubbish, wires or other objects in the area
where the snow is being cleared.
2. Check that all the assembly parts (nuts and screws etc.) are firmly tightened so
that the machine is in safe working condition.
3. Check are regular intervals that the snow screw is not worn.
4. Point the snow ejector in a safe direction. Do not point the snow ejector at
yourself, other persons or objects.
5. Clear snow frequently to prevent it getting too deep. Clear snow as soon as
possible after a snowfall for the best results.
6. Lift up the snow screw a little before starting the machine.
7. Tilt forward the machine until the scraper blade touches the ground. Push
forward the machine at a convenient speed, but slowly enough to clear all the
snow from the ground. The forward speed will depend on the depth of snow.
8. Clear snow to the right or left by holding the machine at a slight angle.
9. The machine can handle a depth of snow of up to 10 cm in each sweep. If the
snow is deeper, hold both handles and work with a sweeping or brushing
movement. "Shave" off the top layer and make several sweeps.
Fig 3
10. Large areas need to be cleared with a definite working pattern to remove all
the snow. The working pattern prevents snow accumulating where it is not wanted.
Pattern 1
Throw the snow to the right or left side (where possible). For example, on a long
drive it is advantageous to start in the middle (top diagram). Clear paths from one
end to the other and throw snow on both sides.
Fig 4.
Pattern 2
If snow can only be thrown on one side of the drive or path, start on the opposite
side (with the snow ejector pointing to the throw area).
Fig 5.