Villager Villybot 1.1, Оригинальное руководство пользователя, Страница: 35 / 229

11
Villager Villybot 1.1 (GB)
If there are areas in your lawn where you do not want your robot to mow, you
encircle the area with boundary wire as indicated on earlier pages.
Note: max. 5 mm between in- and outgoing boundary wire (see drawing on earlier
page).
Insert your final peg when you are back at the docking station.
In case the included 100 m wire is not sufficient, you can buy more wire.
Use the included wire joints for assembly.
You do not need to strip the wire ends for the assembly.
Connect the boundary wire to the docking station:
The wire buckles included in the box must be clamped on to the wire by means of
flat-nose pliers. When you connect the wire ends to the docking station there is an
IN-wire and an OUT-wire as indicated. The IN-wire is threaded through the wire
holder under the docking station and must be connected to the IN-plug, whereas
the OUT- wire must be connected to the OUT-plug.
You can now fix the docking station to the ground by screwing the 4 safety plugs
into the ground.
1. IN – from under the
docking station (end of
wire) 2. OUT - to the
lawn (start of wire))
After connecting IN and OUT wire,
put the protection cover on.