Villager Villager VCB 6E, Оригинальное руководство пользователя

Страница: 22 / 95

Villager
VCB 6E (GB)
10
To charge the battery, proceed according to the following instructions:
Figure 1: Remove the caps from the battery.
Figure 2: Check the fluid level in the battery and if necessary top up with distilled
water.
Figure 3: First, connect the red wire to the positive terminal of the battery.
Figure 4: Then connect the black wire to the negative terminal of the battery.
Figure 5: When the battery is properly connected to the charger, you can connect
it to the power supply 230 V.
Figure 6: The only way to determine the status of the battery, that is the new
charging status of the battery is the use of electrolyte density meter.
Please note: gases evaporate during charging!
Figure 7: Unplug the charger from the power supply.
Figure 8: First, remove the black power cord from the battery negative terminal.
Figure 9: Then remove the red power cord from the battery positive terminal.
Figure 10: Return the battery caps to their place.
Overload protection
Figure 11: Flat fuse protects from the replacement of poles and short circuit. Faulty
fuse must be replaced with new one.
•
Note: In the event of thermal overload charger will turn off. Turn it on again after
an interval of cooling.