Villager VGI 2400, Руководство пользователя

Страница: 51 / 297

19
Villager VGI 2400 (GB)
Never connect generators that are different models.
•
Only connect this generator to another same type and model Generator.
•
Only use our approved parallel operation cable kit to connect generators.
•
Do not run generators in parallel operation in excess of 30 minutes.
•
The parallel cable must be removed if operating only one generator.
•
Never disconnect or remove the parallel operation cable while generator is still
running.
Don’t Overload Generator
Make sure you can supply enough rated watts for all electronic devices connected
to the generator. Rated watts refer to the power a generator must supply to keep a
device running. Surge watts refer to the power a generator must supply to start an
electronic device. This power surge for starting a device usually lasts between 2-3
seconds but this additional output must be taken into account when selecting the
electronic devices you plan to attach to the generator. To prevent overloading the
generator take the following steps:
1. Add up the total rated wattage of all electronic devices that will be connected to
the generator simultaneously.
2. Estimate surge watts by adding the item(s) with the highest output (it is
unnecessary to calculate the surge output for all devices as they should be
connected one at a time).
3. Add the Surge Watts to the total Rated Watts in step 1. Keep total load within
generator’s power capacity .